Coralife Bio Cube Instrucciones de operaciones descargar pdf (Pagina 17)

Inside Hood Wiring for LED Strings to V+ and V-

Each driver has a V+ and V- output that powers the LED strings. Since we cannot put the drivers

in the hood next to the LEDs, we will attach some wire to the driver jumpers and run that through the

empty space left from removing some of the power cords.

We start by running our wire through the void left by one of the cut power cords.

Next, we run it through the rubber grommet separating the interior of the protected hood from the

exterior. Tie a loose knot around the strain relief post to prevent damage to internal components if the

outer wires get pulled too hard.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Coralife Bio Cube Instrucciones de operaciones Pagina 17